Open the Image Sensor Configuration dialog (only available on dual cameras) to configure the image sensors of the camera that are to be used for the right and the left camera image. The MOBOTIX cameras M15, S15D and S15M are automatically listing the installed or attached sensor modules.
MxDigitizer (S15D and S15M only, see below)
The MxDigitizer is an analog digital converter and allows using analog cameras with an S15D or an S15M. For the camera, the device behaves like a regular sensor module.
On D15 models with 6MP image sensors, you can also set the type of lens carrier if a different one than the factory default setting has been installed. For example, if a camera had been delivered as 180° model ("Panorama"), you can later install separate lens units.
This dialog is only available on camera models with connectors for external sensor modules (e.g. D14D, D15, M15, S14D, S15D).
You cannot use the same image sensor for the right and the left image sensor.
If the camera should use only one image sensor, you need to select the sensor in the dropdown box for the right camera image.
If you select No sensor for both camera images, the camera will automatically detect the image sensors when rebooting. While doing so, the camera will set the attached image sensors for the right and the left camera image in this order:
External sensor Cam1 (highest priority)
External sensor Cam2
On-board sensor (lowest priority)
If you have installed different lenses, make sure that you are selecting these lenses in the Lens Configuration dialog, so that the lens correction works properly.
Click on the Set button to permanently accept this setting. In order to enable these settings, you need to reboot the camera.